Blowing machine maintenance maintenance five notes:

1. The bottle of the blow molding machine always pinches the orientation of the manipulator.

2. The bottle of the blowing machine cannot be taken out of the mold after being blown. It is necessary to open the mold roughly, and use the manual opening and closing mode. If it is normal, run it in the air running condition, if it is normal.

Please check your exhaust time setting. If the exhaust setting is normal and you only need one blown bottle at a time, then you can judge the exhaust valve. Please open the exhaust valve to check the spring and seal. Condition (There is also a phenomenon in which the exhaust sound is loud or has a bad sound).

If you are experiencing a lot of mold production and occasionally come to this situation, please check whether the lock pin has a segment of the screw inside, in addition, please check whether the clamping force is too large, if too large Probably adjusted from the beginning according to the specifications.

3. the blowing machine feeding position is not added, need to check several conditions: Is it now that the hopper is not expected, if it is: need to feed quickly; not: please check the blower hoist control contactor is not The electrical condition, if it is a power-on condition, the motor is not in the power and load condition as soon as possible. Since this condition is likely to be caused by the preform (embryo) stuck in the lifting belt, the simple method is to assist the lifting manually.

If you look at the control contactor of the blower hoist is not in the power state, please check the preform to check whether the electric eye is not in the same line as the reflector.

4. blowing machine feeding old card feeding tray: This situation is a question of contrast headache, from the experience point of view, if the length of the preform (embryo) is larger than the long cut component, then this phenomenon is less contrast .

5. Collision between two robots: The condition requires manual reset of the robot from the head, which is caused by misalignment.